Search for: All records

Recent efforts towards energy scavenging with eco-friendly methods and abundant water look very promising for powering wearables and distributed electronics. However, the time duration of electricity generation is typically too short, and the current level is not sufficient to meet the required threshold for the proper operation of electronics despite the relatively large voltage. This work newly introduced an electrochemical method in combination with hydro-effects in order to extend the energy scavenging time and boost the current. Our device consists of corroded porous steel electrodes whose corrosion overpotential was lowered when the water concentration was increased and vice versa . Then a potential difference was created between two electrodes, generating electricity via the hydro-electrochemical method up to an open-circuit voltage of 750 mV and a short-circuit current of 90 μA cm −2 . Furthermore, electricity was continuously generated for more than 1500 minutes by slow water diffusion against gravity from the bottom electrode. Lastly, we demonstrated that our hydro-electrochemical power generators successfully operated electronics, showing the feasibility of offering electrical power for sufficiently long time periods in practice. 

Abstract Thermoelectrics are suited to converting dissipated heat into electricity for operating electronics, but the small voltage (~0.1 mV K −1 ) from the Seebeck effect has been one of the major hurdles in practical implementation. Here an approach with thermo-hydro-electrochemical effects can generate a large thermal-to-electrical energy conversion factor (TtoE factor), −87 mV K −1 with low-cost carbon steel electrodes and a solid-state polyelectrolyte made of polyaniline and polystyrene sulfonate (PANI:PSS). We discovered that the thermo-diffusion of water in PANI:PSS under a temperature gradient induced less (or more) water on the hotter (or colder) side, raising (or lowering) the corrosion overpotential in the hotter (or colder) side and thereby generating output power between the electrodes. Our findings are expected to facilitate subsequent research for further increasing the TtoE factor and utilizing dissipated thermal energy. 

Solid solutions of Mg 2 Si and Mg 2 Sn are promising thermoelectric materials owing to their high thermoelectric figures-of-merit and non-toxicity, but they may undergo phase separation under thermal cycling due to the presence of miscibility gaps, implying that the thermoelectric properties could be significantly degraded during thermoelectric device operation. Herein, this study investigates the strain-induced suppression of the miscibility gap in solid solutions of Mg 2 Si and Mg 2 Sn. Separately prepared Mg 2 Si and Mg 2 Sn powders were made into (Mg 2 Si) 0.7 (Mg 2 Sn) 0.3 mixtures using a high energy ball-milling method followed by spark plasma sintering. Afterwards, the phase evolution of the mixtures, depending on thermal annealing and mixing conditions, was studied experimentally and theoretically. Transmission electron microscopy and X-ray diffraction results show that, despite the presence of a miscibility gap in the pseudo-binary phase diagram, the initial mixture of Mg 2 Si and Mg 2 Sn evolved towards a solid solution state after annealing for 3 hours at 720 °C. Thermodynamic analysis as well as phase-field microstructure simulations show that the strain energy due to the coherent spinodal effect suppresses the chemical spinodal entirely and prevents phase separation. This strategy to suppress the miscibility gap induced by lattice strain through non-equilibrium processing can benefit the thermoelectric figure-of-merit by maximizing phonon alloy scattering. Furthermore, stable solid solutions by engineering phase diagrams have the potential to facilitate the reliable long term operation of thermoelectric generators under continuous thermal loads.